微信 跳一跳 物理外挂

之前 刚有微信小程式的时候做的一个东东, 物理外挂
老婆很给面子 不过最打到260+ 毕竟是棉花签做杠杆~~~
不是很会写 瞎抄人家的

	/*
	Stepper Motor Control - one revolution
	This program drives a unipolar or bipolar stepper motor.
	The motor is attached to digital pins 8 - 11 of the Arduino.
	KC trial for Camera filter wheel
	Date: 06/14/2019
	*/
	#include <Stepper.h>
	const int stepsPerRevolution = 2048; // change this to fit the number of steps per revolution
	const int stepsEachFilter = 320; // each angle is 56.25
	const int stepsBacktobeginning = 1600; // back to beginning
	// for your motor
	// initialize the stepper library on pins 8 through 11:
	Stepper myStepper(stepsPerRevolution, 8, 9, 10, 11);
	/*
	* pin8->controller IN1
	* pin9->controller IN3
	* pin10->controller IN2
	* pin11->controller IN4
	* https://forum.arduino.cc/index.php?topic=86339.0
	*/
	void setup() {
	// set the speed at 60 rpm:
	myStepper.setSpeed(10);
	// initialize the serial port:
	Serial.begin(9600);
	}
	void loop() {
	// step one revolution in one direction:
	Serial.println("frist");
	myStepper.step(stepsEachFilter);
	delay(1000);
	Serial.println("second");
	myStepper.step(stepsEachFilter);
	delay(1000);
	Serial.println("third");
	myStepper.step(stepsEachFilter);
	delay(1000);
	Serial.println("forth");
	myStepper.step(stepsEachFilter);
	delay(1000);
	Serial.println("fifth");
	myStepper.step(stepsEachFilter);
	delay(1000);
	Serial.println("back");
	myStepper.step(stepsBacktobeginning);
	delay(1000);
	}

view raw Jump one Jump hosted with ❤ by GitHub